Construction:
U - Profil
The frame parts must be screwed together with flange connections
With supports 500 mm height at a distance of about 3000 mm
Drive drum:
Diameter 320 mm, cylindrical, rubberized 8 mm thick including 60s wave, pillow block bearings and clamping sets
Tension drum:
Diemater 320 mm, cylindrical including 60s wave, pillow block bearings and clamping sets
Idler stations:
In the upper run: 3-part, 15-30 grad througt
In the lower run: 1-part
Spacing in the upper run: 1,000 mm
Spacing in the lowerun: 3,000 mm
Spacing feeding zone: 230 mm
Idler:
Diameter 88.9/20/SW 15 with labyrinth seal, lubricated for life
Drive:
Bevel spur gearbox-motor - specifically designed for belt conveyors with anti retour or on demand with brake (except for horizontal belt conveyors)
Belt:
Rubber belt EP 400/3, smooth, for belt conveyor up to 18° ascent angle
Up to 30 meter endless length, about this length the belt have to be connected by the customer
Feeding chute:
Length 1.500 mm with adjustable skirtboards
Inner belt cleaner:
Plough scraper system BEKA
Outer belt cleaner:
Pre scraper Type Rasmus, scraperblade in polyurethane, with spring tension
Emergency stop:
Emergency stop with pull-wire switch normed EN 418 with pull cord 3 mm
Protection systems:
Protective devices on drive- and tension drum acc. safety regulations
Surface coating:
Surface Coating finished with one layer of zinkphosphate primer and two layers of paint, dry-film thickness 120µm in RAL 6011
The belt conveyors are without electrical connection and motor overload protector
|
